AI Music Video Generator

Tone generator.

A frequency generator that plays one pure tone at a time, anywhere from 20 Hz to 20 kHz. Sine, square, sawtooth or triangle, to one decimal place, with a sweep for testing speakers. It runs in your browser, so there is nothing to install.

440 Hz

Sine wave

20 Hz20 kHz

One frequency and nothing else. The right choice for tuning, hearing checks and measuring.

Sweep

Glides from one frequency to another, logarithmically, so each second covers the same number of octaves. Play it through a speaker and listen for the places it rattles, drops out or buzzes — those are the speaker or the room, not the file.

10.0 octaves

Speakers checked. Now what does the song look like?

Do you want more monthly listeners?

Tap to choose your song

MP3, WAV, M4A or AAC, up to 150 MB

No account, no card. Decide once you've seen it.

What to know first

Start quiet. A steady tone is far louder to the ear than music at the same level, because music moves and this does not. On headphones a sine wave at a level that seems fine for a song is uncomfortable within seconds, and a high one can do real damage before it feels loud. Set the level low, then raise it.

Use the sweep to find what a room does. Play 20 Hz to 200 Hz through a speaker and listen. Places where it suddenly booms or vanishes are standing waves between your walls, not a fault in the speaker; things that buzz on one note and stop on the next are usually a loose panel or a badly seated driver.

The waveform decides the harmonics. A sine is one frequency alone, which is what makes it the right choice for tuning and for hearing checks. A square holds the odd harmonics at full strength and is far more revealing of distortion. A sawtooth holds every harmonic and is the brightest of the four.

Tuning by ear works from 440 Hz. That is A above middle C, the pitch orchestras tune to. Play it, match your string to it, then work across the instrument by fifths. For anything more exact than that, the guitar tuner reads the pitch back to you to the cent.

A hearing check here is not a hearing test. Whether you can hear 15 kHz through your own headphones tells you about your ears and your headphones together, and most consumer headphones roll off well before 20 kHz. Losing the top is also normal with age rather than a sign of damage.

The square and sawtooth are band-limited. Built naively, those shapes have harmonics above half the sample rate, which fold back down as out-of-tune whistling. The browser's oscillator builds them without those harmonics, so what you hear at 5 kHz is a real square wave rather than a mess.

Questions

What is a tone generator for?
Testing speakers and headphones, finding rattles and room resonances, tuning by ear, checking the top of your hearing, and calibrating equipment against a known frequency. Anything that needs a sound with one frequency and nothing else in it.
Is this the same as a frequency generator?
Yes. Tone generator, frequency generator and signal generator all describe this: something that produces a single chosen frequency. Hardware signal generators do more, but for audio work in air this is the same job.
What frequency range can it play?
20 Hz to 20 kHz, which is the usual span of human hearing. Whether you hear the ends of it depends on your speakers as much as your ears — most laptop speakers produce nothing useful below about 150 Hz.
What does the sweep do?
It glides from one frequency to another over the time you set, logarithmically, so each second covers the same number of octaves. That is how you find the frequencies where a speaker or a room misbehaves.
Which waveform should I use?
Sine for anything you are measuring or tuning, because it contains one frequency and nothing else. Square or sawtooth when you want to hear distortion or drive a speaker hard, since both carry strong harmonics.
Can I test one speaker at a time?
Yes. Set the channel to left only or right only. It is the quickest way to find out whether a cable is in the wrong socket or a driver is dead.
Is it safe for my speakers?
At sensible levels, yes. A sustained low tone at high volume is the one thing to be careful of: a tweeter or a small driver asked to hold 30 Hz loudly for a long time can be damaged, because nothing in music asks that of it.

Other free tools

Still here? Then you care how it looks.

Do you want more monthly listeners?

Tap to choose your song

MP3, WAV, M4A or AAC, up to 150 MB

No account, no card. Decide once you've seen it.

Do you want more monthly listeners?

Try it free